YESO TIPO P® / TYPE P PLASTER®

B4 LIGHTENED CONSTRUCTION PLASTER (UNE-EN 13279-1)

High-performance lightening single-layer mechanical projection plaster high Perlite content suitable for interior trim of walls and ceilings. Excellent thermal and acoustic properties.
This plaster has a special progressive setting with allows immediate projection straightening, which cuts down on working time.

HOW TO USE
– Prepare the surface ensuring it is free of dust and loose particles, rough spots, oil stains and other residues that may reduce its adhesion.
– It is recommended to moisten the application surface with water or apply a regulating primer if the absorption of the surface is very high.
– In the case that the support is too smooth, a product that favours adhesion should be applied.

APPLICATION
– Project regulating the flow of water to obtain a consistent and workable paste.
– Smooth using an aluminium ruler to obtain a flat surface.
– Small imperfections may be cut off using a steel blade.
– Apply MAX FINE for the perfect finish.

APPLICATION CONDITIONS
– The recommended thickness of the coat is between 1cm-2cm.
– The temperature during application should not be lower than 5ºC or above 40ºC.
– The relative humidity should not exceed 70%.
– It is not advisable to apply the product during wet weather as this may have adverse effects.

DECORATING AND FINISHING
– This product must dry naturally. it is not advisable to dry the plaster artificially using air cannons or other devices.
– It is advisable to apply a primer before painting to regulate surface absorption.
– Ensure to follow any guidelines indicated by the paint manufacturer.

STORAGE
– Store the product in a dry environment where it is not in contact with the ground.
– Once a package has been opened it is recommended that it be sealed and used before a new sack is opened.

TECHNICAL CHARACTERISTICS
Purity Index >70%
Plaster/water ratio 60% plaster / 40% water
Setting time (start) 60-80 minutes
Setting time (end)** 200-300 minutes
Flexural strength ≥1N/mm2
Compressive strength ≥2N/mm2
Surface hardness >45 Shore C units
Adhesion ≥0.1N/mm2
Fire class A1

*Usage times may vary according to factors such as: water/plaster ratio, temperature, water pH, support type, etc.
**Setting time in traditional support (ceramic brick or concrete) from the projection.
*** Thermal conductivity coefficient 0.18 λ(W/mK)

PACKAGING
Supplied in 25kg bags in pallets of 48 bags and in bulk.

ESYEDEBRO S.L. advises against the use of its products for applications other than those for which they have been especially designed.